New Glasses View - Coming Soon

1 lurker | 31 watchers
Feb 2014
1:49pm, 14 Feb 2014
7,469 posts
  •  
  • 0
Boab
Ah, that's how the split breaker works. I wasn't aware it included the stops at the road, stops for dogs, stops for the natuarl little boys room, stops for bumping into people you know ;).

Might be worth noting that in the little blue 'i'

I personally think the new look is great. Well done Fetch :)
Feb 2014
1:51pm, 14 Feb 2014
460 posts
  •  
  • 0
K5 Gus
The use of real time data for the Spilt Breaker - would that be affected by running through a tunnel where there is no signal ?

My splits in the Split Breaker are all over the shop today. In my 1st mile I ran thru a tunnel, from approx 0.60 to 0.71 miles into the run. The Garmin split sorts itself once it regains the signal at the end of the tunnel, and it shows the first mile as 8:38 which is pretty accurate I think, but the Split Breaker shows it as 9:24. Those extra 44 seconds must be about the time I was in the tunnel without a signal.........Ran thru the same tunnel on the way back and that last mile split is only 16 seconds difference.

If the splits were pretty close apart from that I could sort of understand, but some of the miles are quite close, and others are out by 30 secs, and there were no more tunnels, and no pausing the watch.
Feb 2014
2:27pm, 14 Feb 2014
461 posts
  •  
  • 0
K5 Gus
Altitude Gain issue - my last 2 runs ( yesterday and today ) show the elevation gain and loss no problem when I look at them in the glasses view, however the same data is not showing :-
a) on the Training Log list when Terrain is chosen
b) in the Weekly Run Asscent graph on the LHS of the main Train page
c) when I go to edit these 2 sessions, and remain at 0 if I F5 refresh the page.

Is it just calculating it every time you go into Glasses View and not "saving" it as part of the activity? Is their something you need to do to save it ?

Thanks
Feb 2014
2:29pm, 14 Feb 2014
462 posts
  •  
  • 0
K5 Gus
Oops - apologies, just seen that the altitude issue was reported by someone else on previous page of the thread
Feb 2014
5:25pm, 15 Feb 2014
688 posts
  •  
  • 0
JRitchie
I like it :) Could the bar you get to move on the map bit also tie into a line on the graph bit (Can you tell I'm not in IT).
Feb 2014
2:24pm, 16 Feb 2014
172 posts
  •  
  • 0
andy@6nwn
Just noticed a few strange things.

Last run (Friday) and ride (today) show up perfecting in the glasses view. Both were imported from a Fenix using FIT file. This has worked in the past but now in "your log" it says "no specific route" and for todays ride the glasses page does not load properly (the run of Friday shows up ok). The FIT opens ok in BikeHike and I saved it to a GPX track and got exactly the same issue (although this time the glasses view does look good)Also seems that todays ride has not appeared on Conqurrcise.

The training log also suggests I completed in 3:03 but it certainly took me 30 mins longer than that.

Sorry, bit complicated - hope it makes sense
Feb 2014
2:26pm, 16 Feb 2014
14,036 posts
  •  
  • 0
fetcheveryone
Andy - regarding the route, see point 6 in the thread header. Could you email the FIT to me at ian AT fetcheveryone.com so I can take a look?

JRitchie - that's in point 7 in the thread header.
Feb 2014
3:40pm, 16 Feb 2014
174 posts
  •  
  • 0
andy@6nwn
sent, thanks
Feb 2014
7:32pm, 16 Feb 2014
29,822 posts
  •  
  • 0
Foxy
Fetch - only her as just noticed training routes aren't showing in my training log - not the end of the world.

Just seen point 6 - Am i correct in saying for Conquercise & Fetchpoint it doesn't matter & i still get zones credited ? but when i look back will on an individual entry will have no idea where I ran ?
Feb 2014
7:37pm, 16 Feb 2014
14,037 posts
  •  
  • 0
fetcheveryone
Click glasses, see route.

About This Thread

Maintained by fetcheveryone
1) the off- and on-able graph lines in the top graph.
2) the split breaker. No longer does it show your split times in hard-to-work-out seconds, and the data table beneath it should also be useful.
3) cadence and power graphs for those that record it
4) a few nods to the different requirements of swim/bike/run - colour coded graphs, no ascent/descent for swims, more appropriate split options for swims.
5) works with no lat/lng data in your file - good for turbo, treadmill, pool swims
6) no automatic saving of route e.g. "Imported from your Toaster - 2014-02-10" - but you can name & save route with one click if it's special. If you play Conquercise or Fetchpoint, you don't have to do ANYTHING differently. Reports of a few bugs in Fetchpoint as a result, I'm working on those.
7) the ground work for changing the top graph into a javascript-based one that will integrate directly with the map slider, and show a tooltip for wherever you are on the graph. Playing with that in dev.
8) reclaiming notes field for notes. Still captures basic split information, but pace/hr bands etc now in their own graphs. Similar updates to user profiles on the cards so you can see how others are training (but expect it to be restrictable by the owner).
9) Some cute little icons for the weather / conditions. If you always leave these options as 'perfect', 'still' and 'none' then you won't see anything. Think of it as a way of capturing conditions that might have had an impact on your run.
10) Little blue (i)'s that give a bit more information about each of the sections.
11) When you import from file, you can now pre-choose sport - and rather than being taken to the 'edit' screen, you're taken to the 'view' aka the 'glasses' view.
12) Some folks were concerned that watch elevation data gets ignored. This is on purpose - GPS-based elevation data is notoriously inaccurate. When you're taken to the glasses view, elevation profile should pop up after a few seconds, and the ascent/descent likewise. If it doesn't happen, try refreshing the page.

REPORTED BUGS:
1) Westmoors - kit reporting 0 miles.
2) Some issues with the information popups being obscured on RHS of browser window.
3) Some lines extend above top of graph, so peaks are missing.
4) Larkim - choice of sport is being ignored.
5) Ascent/descent not showing on 'list view' nor in weekly graphs.

REQUESTS:
1) Indicator of 'amount of flattening' flattening.
2) Option to reduce flattening (without having to go via reset)
3) Remember flattening setting
4) Option to show paceband, HR band graphs etc as table of data rather than graph.

Related Threads

  • traininglog
  • website








Back To Top

Tag A User

To tag a user, start typing their name here:
X

Free training & racing tools for runners, cyclists, swimmers & walkers.

Fetcheveryone lets you analyse your training, find races, plot routes, chat in our forum, get advice, play games - and more! Nothing is behind a paywall, and it'll stay that way thanks to our awesome community!
Get Started
Click here to join 113,367 Fetchies!
Already a Fetchie? Sign in here